Gas Tankless Water Heater, Gas Tankless Hot Water Heaters

TM-RE30
Temperature Remote Control
The TM-RE30 Temperature Remote Controller allows the output temperature to be adjusted beyond the factory settings, and works as a diagnostic tool for error codes. $138.00

TK-TV13
Wall Ventilation Terminator for Direct Vent
The TK-TV13 Wall vent terminator is used where a tankless hot water unit will be vented through a wall. $117.00

TK-TV10
Direct Vent Conversion Kit
The TK-TV10 direct vent conversion kit can be used to convert the tankless hot water unit from a conventional vent system to a direct vent (or sealed combustion) system. $57.00

TK-TV04
Outdoor Ventilator Cap
The TK-TV04 vent cap kit is installed on the top of the unit to allow outside installation of the tankless unit. $44.00

TK-RB01
Recess Box
The TK-RB01 Recess box completely houses the tankless unit and allows the installation to be entirely recessed into a wall. The recess box measures just over 14 inches wide to easily fit in-between studs. $275.00

TK-PC01
Pipe Cover
The TK-PC01 Pipe cover is designed to be attached directly to the bottom side of the unit to provide a cover for the pipe connection entry. $79.00

TK-KPWH4
Cap Wall Thimble With Hood
The TK-KPWH4 T-Vent wall thimble with hood termination is used when venting out through the wall and are compatible with the T-Vent pipe system. $

TK-IV-01
Isolation Valves & Pressure Relief Valve
Isolation valves are used to isolate a unit for service. The Pressure Relief Valve is to help protect the unit and release if the pressure in the tankless water heater or hot water system exceeds 150 psi. $81.00

TK-BF01
Exhaust Backflow Prevention Kit
The TK-BF01 prevents cold air from entering the vent and causing heat exchanger to freeze. $36.00